Dakota-digital LED Tail Lights for 1957 Chevy Car LAT-NR210 Manuel d'utilisateur télécharger pdf

MAN#650185

INSTALLATION INSTRUCTIONS

LAT-NR210

LED Tail Lights for 1957 Chevy Car

MAN#650185

Kit Includes:

Installation:

1. Remove the three screws that secure the tail light lens and remove the lens.

2. Remove the light bulb

3. Push and twist to remove the plastic wire socket from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the lock nut and flat plastic back plate from the back of the new LED assembly.

6. Make sure that one wire is still going through each hole in the

aluminum spacer. Insert the new LED assembly through the hole

where the original bulb and connector were located. Use caution

when feeding the wires through to avoid damaging the wire

insulation.

7. Guide the wires through the larger hole in the plastic back plate and slide

the back plate onto the stud sticking out the back side of the housing.

Ensure wires are not pinched to avoid shorting!

8. Secure the plastic back plate from the back side of the tail light housing

with the supplied #6 lock nut.

9. Make sure the original lens gasket is in place and replace the tail light

lens. Tighten the screws down carefully.

1 2

MAN#650185 INSTALLATION INSTRUCTIONS LAT-NR210 LED Tail Lights for 1957 Chevy Car MAN#650185 Kit Includes: Installation: 1. Remove the three scr

MAN#650185 10. Start by cutting off the existing light socket as it will not be used. Do not strip wires. Trim the wires from LED assembly to appr

Pas de commentaire

Dakota-digital LED Tail Lights for 1957 Chevy Car LAT-NR210 Manuel d'utilisateur