Dakota Digital 3 Manuel d'utilisateur télécharger pdf (Page 30)

MAN 650066:D

Symptom Possible Problem Solution

-----------------------------------------------------------------------------------------------------------------------------------

The check engine The Engine Control Module Connect a light or similar load

indicator stays on (ECM) needs to see the to the ECM along with the

all of the time. load of a light connected to it. control box.

The Function switches The push-button switches are Momentary push-button or toggle

do not operate not connected to the control switches must be connected to

properly. box. the SW1 and SW2 terminals

as described in the manual.

The wrong type of switch is The switch terminal connected

being used. to the control box should

normally be open. When the

the switch is activated, the

terminal should make contact

to ground.

The display system starts Sw 2 terminal is constantly Disconnect or replace the

up in the demonstration connected to ground. SW2 switch.

mode and remains in it.

Clock Instructions

For VFD systems with a clock built in

If you purchased your instrument system with an optional clock, it must be wired separately. The clock

displays the current time in 12 hour format. The digital clock from Dakota Digital incorporates the reliability and

quality of our standard gauges. These features include:

• Quartz accuracy

• Night dimming feature

• Very low standby power to prevent battery drain

• High visibility VFD display for sunlight readability

Wiring:

Clock

BLACK Connect to a good ground point in the vehicle

RED Connect to switched 12 volt power point

(An accessory terminal will work for this)

ORANGE Connect to a constant 12 volt power point

(This will keep the correct time)

BLUE Connect to the taillight circuit

+12V when lights on for dim function

Operation:

The gauge needs the red, orange, and black wires connected to operate. The red wire should have

switched 12 volt power from an ACC. point on the fuse panel. The orange wire should have constant 12 volt

power. The black wire should be connected to a good ground point. When the blue wire has 12 volts, it will dim the

display for night viewing, this may be wired along with the wire to the DIM terminal on the control box.

1 2 ... 25 26 27 28 29 30 31 32

Pas de commentaire

Dakota Digital 3 Manuel d'utilisateur Page 30