Dakota Digital 3X Series Manuel de service télécharger pdf (Page 31)

MAN 650067:G

Symptom Possible Problem Solution

-----------------------------------------------------------------------------------------------------------------------------------

The Check Engine The Engine Control Module Connect a bulb with one wire to

indicator stays on (ECM) needs to see the keyed power and the other to

all of the time. load of a light connected to it. the CHECK ENG terminal.

The Function switches The push-button switches are Momentary push-button or toggle

do not operate not connected to the control switches must be connected to

properly. box. the SW1 and SW2 terminals

as described in the manual.

The wrong type of switch is The switch terminal connected

being used. to the control box should

normally be open. When the

the switch is activated, the

terminal should make contact

to ground.

The display system starts SW2 terminal is constantly Disconnect or replace the

up in the demonstration connected to ground. SW2 switch.

mode and remains in it.

Clock Instructions

For VFD3X systems with an ODYR-16 clock with day/date and temp built in

Features:

• 12 hour format with AM/PM display.

• Day of Week and Date of Month display.

• Outside Temperature display.

• Night dimming.

• High Visibility VFD display for sunlight readability.

Operation:

The white/red wire should be connected to a constant 12 volt feed to keep the time. The red wire should

be connected to a 12 volt accessory feed. The black wire provides the gauge ground. Connect the ring terminal

from the black wire to a screw at the top rear of the case. Attach the loose end of the black wire to a main vehicle

ground and also the temp sensor black wire. When the blue wire has 12 volts, it will dim the display for night

viewing. The gray wire attaches to the temp sensor red wire. The green wire will be used with a remote mount

switch. The remote switch should apply power to the green wire when pressed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Dakota Digital 3X Series Manuel de service Page 31